Application: install the parts as shown in the figure.
Parking brake parts installation diagram
1. Apply high temperature grease to the brake shield as shown.
2. Apply high temperature grease to the regulator as shown.
3. Connect the parking brake cable to the lever
- A) Install retainers, spring seats and retainer springs.
- b) Connect the parking brake cable to the lever.
4. Install the rear shoe, pre-compressing the holder spring.
Caution: Do not allow oil or grease to come into contact with friction surfaces.
5. Install the return spring. front brake pad and regulator.
- A) Connect the return spring to the rear shoe.
- b) Connect the return spring to the front shoe.
- V) Install the adjuster between the front and rear shoes.
- G) Install the front shoe, pre-compressing the retainer spring.
6. Install the spacer plate with the spring against the front shoe.
7. Using the special tool, install the shoe return springs.
8. Install the brake disc.
- A) Sand the disc and pad surfaces with sandpaper before assembling.
- b) Align the hole on the rear axle hub with the service hole on the disc.
9. Adjust the clearance of the parking brake shoes.
- A) Temporarily install wheel nuts.
- b) Remove the plug.
- V) Turn the adjuster to move the pads apart until they block the disc.
- G) Loosen the adjuster eight teeth.
- d) Install the plug.
10 Install the rear caliper assembly and tighten the two mounting bolts. Tightening torque 47 Nm.
11. Install the rear wheel.
12. Driving the vehicle at low speed on a dry, clean and level road, pull the parking brake lever so that the shoes are pressed against the drum. Make sure the pads are worn.
13. Check and adjust the travel of the parking brake lever.