A) Install the seal on the glass and insert the cord into the groove of the seal as shown in the figure.
Note: If the sealing conditions are not met when installing the old seal, install a new seal.
2. Apply soapy water to the mating surfaces of the body flare seal flange.
A) Fix the glass in its place in the body.
Note: glass installation should be started from the middle of the lower part.
b) From the outside, pull one of the ends of the cord, placing it at an angle to the seal, so that the cord pulls the seal flange behind the body flange. At the same time, from the inside, press the glass along the seal until the glass snaps into place.
3. Install the cab rear window seal.
A) Apply soapy water to the mating surfaces and install the seal starting from the center of the underside.
4. Check the tightness of the connections. Repair if there are leaks.