A) Put marks on the flanges for their subsequent alignment.
b) Loosen the four nuts and bolts
Cardan shaft:
1 - Cross bearing,
2 - Cross,
3 - Flanged fork,
4 - Oil seal,
5 - cardan shaft,
6 - Retaining ring,
7 - Fork,
8 - Grease fitting,
9 - duster,
10, 11 - 88 Nm for axle type C, 74 Nm for axle type A and B.
2.1 (Dyna 100) Disconnect the propeller shaft from the gearbox.
A) Remove the fork from the gearbox.
b) Insert a plug into the gearbox to prevent oil from escaping.
2.2 (Dyna 150)
A) Apply alignment marks to the flange and parking brake drum.
b) Loosen four screws.
Note: The parking brake is located between the gearbox and propeller shaft.