a) The indicator lights up if
- parking brake on;
- the brake fluid level is low or the brake booster is not sealed properly;
- the electrical circuit of the indicator is faulty.
b) If the indicator lights up while driving, slow down, pull off the road and stop the vehicle carefully.
- Check the parking brake, it may be on. If the parking brake is off or the indicator lights up after it is off, there is a problem with the brake system.
- Check the brake fluid level in the reservoir.
- If the brake fluid level is low, check the vehicle's braking efficiency in a safe location. If you think the brakes are still working well, carefully drive the vehicle to the nearest repair facility. If the brakes do not work, the vehicle must be towed or removed for repair.
Warning: Driving a vehicle with low brake fluid is dangerous.
- If the brake fluid level is normal, then the brake booster may not be working effectively or the indicator electrical circuit may be faulty.
2. ABS indicator.
After turning on the ignition, the indicator lights up for a few seconds and then goes out. If the indicator lights up while driving, there may be a malfunction in the anti-lock system.
Caution: Pressing the brake pedal repeatedly may cause the indicator to come on for a few seconds.
3. Battery charging indicator lamp.
a) The indicator lamp lights up when the battery is discharged.
b) If the indicator light comes on while driving, the charging system is faulty or the alternator belt is loose. However, the engine will continue to run until the battery is completely discharged. Turn off the additional equipment (air conditioner, fan, radio, etc.) and move to the repair site.
4. Engine oil pressure warning light.
a) The indicator lights up if the engine oil pressure is too low.
b) If the indicator lamp flashes or lights up continuously while driving, pull off the road to a safe place and stop the engine immediately.
- - The indicator may flash after sudden braking or when the engine is idling. There is no malfunction if the indicator goes out with a slight increase in engine speed.
- The light may come on when the engine oil level is too low. However, this light is not intended to inform you about low oil levels, so check the level periodically with the dipstick.
Instrument panel
5. Low oil level indicator. The indicator informs the driver about the low oil level in the engine. It is not recommended to start driving with the indicator on, but oil should be added according to the requirements specified in Chapter "Maintenance".
The indicator may light if the vehicle is on an uneven surface, such as a slope.
6. Indicator "CHECK ENGINE". The indicator lights up if there are any faults in the engine management system.
7. Low fuel indicator. The indicator turns on when the fuel level in the tank approaches zero. Depending on the vehicle's configuration, the fuel may be sufficient for 40-60 km of travel on a good road. On slopes or when turning, the indicator may light up due to fluctuations in the fuel in the tank.
8. Driver's seat belt indicator.
The indicator lights up when the ignition is turned on for a few seconds and then goes out. If the driver is not wearing a seat belt, the indicator lights up on the instrument cluster and an audible signal is activated.
9. Indicator of the presence of an open or loosely closed door.
The indicator remains on until all doors are completely closed.
10. Sound alarm when the door is opened.
The horn will sound if the driver's door is opened while the ignition key is in the "LOCK" or "ACC" position.
11. Glow plug indicator (diesel engines) informs the driver that the starting aid system has started to operate. In this case, the ignition key is in the "ON" position. It is recommended to start the engine only after the indicator goes out.
12. Water presence indicator in the fuel filter (diesel engines) lights up if there is water in the fuel filter. It is necessary to remove the water from the filter before you can start driving.
13. Odometer and trip meters.
a) The odometer shows the total mileage of the vehicle.
b) The trip meter shows the distance traveled since the last time the meter was reset to zero.
c) The button located to the left of the speedometer is used to reset the odometer readings to zero.
