Contents: Examination ↓ Removal and installation ↓
Examination
1. Measure the resistance between the sensor connector terminals.
- Nominal resistance - 1.0 -1.8 kOhm
If the value does not correspond to the nominal value, replace the sensor.
Front wheel speed sensor.
1 - mudguard,
2 - speed sensor and wiring harness.
2. Check for conductivity between each of the terminals and the sensor body. If there is conductivity, replace the sensor.
3. Check the sensor rotor for scratches, cracks, deformation or missing teeth.
4. Measure the gap between the rotor and the speed sensor.
- Nominal clearance - 1.0 mm
5. Check that the wheel speed sensor is installed correctly and that the tightening torque of the sensor mounting bolt corresponds to the permissible value.
- Tightening torque - 19 Nm
Removal and installation
Note:
- Carry out removal in accordance with the figure "Rear wheel speed sensors".
- Installation is carried out in the reverse order of removal.
- Tightening torques are shown in the figure.
See the source on the internet resource [ToyotaMan.ru]
Rear wheel speed sensor.