Examination
1. Measure the resistance between the sensor connector pins.
- Rated resistance - 1.0 - 1.8 kOhm
If the value is out of specification, replace the sensor.
2. Check for continuity between each of the leads and the sensor housing. If there is continuity, replace the sensor.
3. Check the sensor rotor for scratches, cracks, deformation, or missing teeth.
4. Measure the gap between the rotor and speed sensor.
- Nominal clearance - 1.0 mm
5. Check the correct installation of the wheel speed sensor and the compliance of the tightening torque of the sensor fastening bolt with the permissible value.
- Tightening torque - 19 Nm