Car gearbox repair Toyota Land Cruiser 60/80
The cars in question are equipped with a 4- or 5-speed manual transmission or automatic transmission. Repair of these units should be carried out in a car service due to the lack of spare parts for sale and the complexity of repair procedures. Only new or remanufactured units are used for spare parts. Self-performed procedures include only the removal and installation of the gearbox.
The vehicles are fitted with 4-speed transmissions with a locking torque converter. Since 1993, the automatic transmission has been equipped with a self-diagnostic system, which is started from the Overdrive button. Transmission repair with complete disassembly is carried out only in a car service. You can remove and install the transmission yourself, as well as perform certain types of maintenance, adjustment and diagnostic work.
Tightening torques (Nm) Clutch housing mounting bolts 57 Gearbox housing bolts to clutch housing 57 Transmission to rear crossmember mounting bolts 52 Crossmember to frame mounting bolts 52
Attention! In the procedures described below, the gearbox is removed and installed together with the transfer case. Removal 1. Disconnect the battery from ground. 2. Unscrew the lever handle, unscrew the screws and...
Tightening torques (Nm) Transmission to engine mounting bolts: - bolts 17 65 - bolts 14 33 - bolts for 12 16 Torque converter mounting bolts, 49 Transmission to rear crossmember mounting bolts 52 Rear crossmember to...
Attention! The main reasons for abnormal transmission operation may be engine failure (loss of power), incorrect adjustments, failures of the hydraulic transmission system, mechanical drive and processor control system....
Layout of automatic transmission self-diagnosis system units 1. Main O/D switch; 2. Transmission fluid temperature sensor; 3. Transfer case lock switch; 4. Position sensor L4; 5. Speed sensor N1; 6. Transmission...
Examination 1. Move the selector lever through all positions and ensure that the transmission shifts into the appropriate gears. 2. Move the selector lever to the Neutral position and make sure the transmission is in...
Location of selector locking system nodes 1. Key lock solenoid; 2. Selector lock solenoid; 3. Selector control unit; 4. Selector lock switch; 5. Brake light switch The system ensures that the selector is fixed in the...
1. Make sure that there are no deformations on the cable bracket, and that the rubber boot is intact and correctly installed. 2. Press the throttle pedal all the way down. 3. The throttle valve should be fully open,...
Checking the contacts of the locking switch (1988-90.) Checking the contacts of the locking switch (1991-92.) Checking the contacts of the locking switch (1993-94.) Checking the contacts of the locking switch (1995-97.)...
1. Rock the transmission by inserting a large screwdriver between the mount and the bracket. 2. The support must not move away from the bracket. 3. To replace the support, support the transmission, unscrew the bolts and...
Removal 1. Disconnect the battery from ground. 2. Loosen the fan shroud bolts. 3. Disconnect the throttle cable and retract the cable toward the transmission. 4. Remove the transfer case lever handle and boot. 5. Raise...
➥ Manual gearbox Toyota Corolla E80 (1983-1990)
➥ Mechanical gearbox Toyota Corona T190 (1992-1997)
➥ Manual gearbox Toyota RAV 4 XA20 (2000-2005)
➥ Mechanical gearbox Toyota 4Runner N120 (1989-1995)
➥ Mechanical gearbox Toyota Camry XV10 (1991-1996)
➥ Mechanical gearbox Toyota Duet (1998-2004)
- General information
- Introduction to the guide
- Controls and instruments
- Maintenance
- Power unit
- Petrol engines
- Diesel engines
- Cooling and heating
- Power and exhaust systems
- Engine electrical equipment
- Engine management systems
- Transmission
- Automatic gearbox
- Transmission line
- Chassis, running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits
- General information
- User manual
- Maintenance
- Power unit
- Petrol engines 2F and 3F-E
- Petrol engines 1FZ-FE
- Engine overhaul
- Engine electrical equipment
- Cooling and heating
- Fuel system (carburetor)
- Fuel system (injector)
- Toxicity reduction system
- Transmission
- Car gearbox
- Clutch
- Transfer case
- Drive shafts and axles
- Chassis, running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior and interior
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits
- General information
- User manual
- Maintenance
- Power unit
- Engine adjustment
- Engine repair
- Fuel system
- Control system
- Turbocharging system
- Cooling and lubrication system
- Charge and start system
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Transfer case
- Chassis, running gear
- Car suspension
- Brake system
- Steering
- Body and interior
- Body elements
- Heating and air conditioning
- Electrical equipment
- Equipment and devices
- Electrical circuits

