When installing, pay attention to the following operations:
1. Install O-rings on transfer case, press fit and apply grease.
2. Install the rear engine mount bracket:
A) Install the bracket bolt to the engine "A", but don't over tighten.
b) Tighten the bolts "IN","C", "D".
V) tighten bolt "A".
G) tighten bolt "E".
Models up to 05.2000
Models since 05.2000
3. Connect rods #1 and #2.
4. Connect the front drive shaft.
5. Install the cardan shaft.
6. Install the exhaust pipe.
7. Fill oil into the transfer case.
8. Connect a wire of the negative plug of the storage battery.