- Bearing preload: 0.59 - 0.98 Nm
Measuring the preload of the rear axle gearbox bearing [Toyota Duet M100]
Using a torque wrench, measure the pinion bearing preload.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
The article material has been checked: Kolokoltsev Grigory
Share information:
Similar articles on other Toyota models
➥ Checking the level and replacing the oil in the rear axle… Toyota Camry Vista V40 (1994-1998)
➥ Checking the oil level in the rear axle gearbox Toyota Corona T190 (1992-1997)
➥ Checking the oil level in the rear axle gearbox Toyota Carina T190 (1992-1996)
➥ Rear axle gearbox Toyota Cruiser 70 (1985-1996, diesel)
➥ Bearing, seal and axle shaft of the rear axle Toyota 4Runner N120 (1989-1995)
➥ Rear hub assembly with bearing — removal and installation Toyota Highlander 1 (2000-2007, petrol)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Petrol engines 1.0 l
- Petrol engines 1.3 l
- Engine overhaul
- Cooling system
- Lubrication system
- Fuel injection system
- Starting and charging system
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts and cardan
- Chassis, running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Body elements
- Heating and air conditioning
- SRS security system
- Electrical equipment
- Equipment and devices
- Electrical circuits
- Petrol engines «Y»
- Checks and adjustments
- Overhaul engine
- Cooling and lubrication system
- Fuel system
- Starting and charging system
- Ignition system
- Diesel engines «L»
- Engine repair
- Cooling and lubrication system
- Fuel system
- Starting and charging system
- Transmission
- Clutch
- Manual gearbox
- Cardan shaft
- Chassis, running gear
- Car suspension
- Brake system
- Steering
- Electrical equipment and body
- Body elements
- Equipment and devices
- Electrical diagrams