Camry Corolla Corona Carina Land Cruiser Highlander 4Runner RAV4 Others

Carina T190 (1992-1996) Carina T170 (1988-1992)

Checking the deceleration sensor (4WD) [Toyota Carina T190]

0

1. Check the battery voltage with the ignition off.

Nominal voltage - 10-14 V

2. Disconnect the sensor connector and check the resistance between the connector terminals (see table).

Table. Checking the deceleration sensor

Publication Reprinted from a web portal [ToyotaMan]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kondratyeva Ulyana

Share information:

◀ Previous

Carina T190: Brake system

Next ▶

Rear Wheel Speed Sensors — Removal and Checking
Rear wheel speed sensor design
Front Wheel Speed Sensors — Removal, Checking and Installation
Front Wheel Speed Sensor Design
Control relay — check

Checking the ABS circuit

Similar articles on other Toyota models

➥ Fuel Level Gauge Sensor — Checking and Replacing Toyota Camry XV20 (1996-2001)
➥ Checking the oil pressure indicator sensor Toyota Corolla E80 (1983-1990)
➥ Checking the knock sensor Toyota Corona T190 (1992-1997)
➥ Inductive sensor — checking and replacement Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Fuel level sensor — checking and replacement Toyota 4Runner N120 (1989-1995)
➥ Air flow pressure sensor — checking Toyota RAV 4 XA20 (2000-2005)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

We require cookies to enable some interactive features. Is that ok with you?