Checking the light sensor [Toyota Carina T190]

1. Remove the instrument cluster assembly.

2. Disconnect the light sensor connector.

3. Check that when terminals "5" or "6" are grounded, the corresponding lamp lights up.

Grounding of terminal "5" - headlights are on
Grounding of pin "6" - side lights are on

4. Perform a check according to the table "Checking the light sensor".

See the source on the internet resource toyotaman.ru

Light Sensor Test Table

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kondratyeva Ulyana

Share information:

◀ Previous

Carina T190: Equipment and devices

Next ▶

Checking the rear side light relay, fog light relay, turn signal relay
Checking the headlight relay
Checking the ignition switch
Relay blocks
Mounting block #2 (in the engine compartment)

Rear window wiper and washer device
Windshield wiper and washer device
Removal the Windshield Wiper Control Switch
Checking the Windshield Wiper Control Switch
Checking the operation of the windshield wiper