a) Remove the clutch cover and clutch disc.
b) Remove the flywheel by unscrewing 6 bolts.
Note: Before removing the flywheel or torque converter drive plate, place marks to avoid disturbing the balance when installing them.
(Models with automatic transmission)
Remove the torque converter drive plate together with the front and rear spacers by unscrewing the 6 bolts.
2. Remove the rear plate of the cylinder block by unscrewing 2 bolts.
3. Install the engine on a stand (machine) for disassembly.
4. Remove the air conditioning compressor.
5. Remove the timing belt and timing pulleys (see section "Timing belt").
This material is taken from a resource www.ToyotaMAN.ru
6. Remove the cylinder head (see section "Cylinder head").
7. Remove the generator and generator tension bar by unscrewing 2 bolts.
8. Remove the right engine mount by unscrewing 3 bolts.
9. Remove the coolant pump (see chapter "Cooling system").
10. Remove the oil filter using a suitable wrench as shown in the figure.
11. (Models with oil cooler).
Remove the oil cooler (see chapter "Lubrication system").
12. Remove the coolant drain plug from the cylinder block.
13. Using a suitable tool, remove the oil pressure sensor.
14. Using a suitable tool, remove the knock sensor.
15. Remove the oil pan and oil receiver with mesh filter (see chapter "Lubrication system").
16. Remove the oil pump (see chapter "Lubrication system").