Installing the clutch release slave cylinder [Toyota Carina T190]

1. Install the slave cylinder and tighten the two bolts.

Tightening torque - 12 Nm

2. Using a special tool, connect the hydraulic tubes.

Tightening torque - 15 Nm

3. Fill the expansion tank with brake fluid and bleed the system.

4. Check for leaks.

[The material is republished from an online website: TOYOTAMAN]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kondratyeva Ulyana

Share information:

◀ Previous

Carina T190: Clutch

Next ▶

Checking the clutch release slave cylinder
Clutch Release Drive Slave Cylinder Assembly
Disassembling the clutch release drive slave cylinder
Removal the clutch release slave cylinder
Installing the master cylinder

Clutch assembly — removal
Clutch release drive slave cylinder device
Clutch device
Clutch assembly — check
Clutch assembly — installation

Similar articles on other Toyota models

➥ Installing the clutch release slave cylinder Toyota Corona T190 (1992-1997)
➥ Clutch release slave cylinder Toyota Camry Vista V40 (1994-1998)
➥ Disassembling the clutch slave cylinder assembly (C251 /… Toyota Corolla Verso 3 (2004-2009)
➥ Clutch slave cylinder — removal and installation Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Clutch slave cylinder — removal and installation Toyota 4Runner N120 (1989-1995)
➥ Clutch slave cylinder — removal and installation Toyota RAV 4 XA10 (1994-2000)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet