2. Install the spring stop on the stem.
3. Install the spring.
- A) Using the special tool, compress the spring.
- b) Install the spring on the strut. Note, install the lower end of the spring into the hole in the lower strut seat.
4. Install the upper vibration damper and the upper rack post.
- A) Install the top support on the piston rod.
- b) Using a vise, hold the top leg of the strut and install the new nut. Tightening torque 49 Nm.
- V) Rotate the top leg of the rack to install it in the direction shown in the figure.
- G) Remove the special tool.
Note: After removing the special tool, check again that the top support is correctly installed.
- d) Install the plug.
5. Install the rear suspension strut with the spring and tighten the three nuts on the top nut. Tightening torque 39 Nm.
6. Connect shock absorber to knuckle. Install two bolts and nuts. Tightening torque 255 Nm.
7. Connect the anti-roll bar to the shock absorber. Tightening torque 64 Nm.
8. Install speed sensor wire (ABS) and brake hose on the shock absorber strut. Tightening torques:
- Hose attachments 29 Nm.
- Bolt of fastening of an arm of wires 5,4 Nm.
9. Install the rear wheel and lower the vehicle. Tightening torque 103 Nm.
10. Install the rear shelf and rear seat.