Note: Orient the lever with the paint mark toward the rear.
2. Install the rear beam
- A) Raise the rear beam
- b) Install the rear beam lower mountings and tighten the six bolts. Tightening torque 64 Nm.
3. Install muffler center pipe and muffler.
4. Install the #2 lower suspension arm.
- A) Install the #2 lower suspension arm with three washers.
Note: Orient the lever with the paint mark toward the rear.
- b) Temporarily install two locknuts.
5. (For vehicles with LSPV) Connect the rear brake force distribution valve spring to the lower control arm. Tightening torque 25 Nm.
6. Install trailing arm and temporarily install two bolts and nuts.
7. Stabilize the suspension.
- A) Install the rear wheel and lower the car. Tightening torque 103 Nm.
- b) By pushing the body down and lifting it up, stabilize the suspension.
8. Tighten nuts.
- A) Jack up the car and place stands under the body.
- b) Remove the rear wheel.
- V) Place a jack under your fist.
- G) Tighten the lower arm nuts and trailing arm mounting bolts. Tightening torques:
- Nut A: 161 Nm
- Nut B: 113 Nm
9. Install the rear wheel and lower the vehicle. Tightening torque 103 Nm.
10. Check rear wheel alignment.
11. Tighten the #2 lower suspension arm locknuts.