Disassembly
- A) Loosen the two locknuts.
- b) Rotate the adjusting tube to disassemble the Ne2 lower control arm.
- V) Loosen the locknuts from the levers.
Assembly
- A) Install the locknuts on the arms.
- b) Rotate the adjusting tube to assemble the #2 lower suspension arm.
Note - when assembling the lower suspension arm No. 2, set the same distances "A" And "IN", shown in the figure. The maximum difference is 3 mm.
- V) Adjust the length of the #2 lower suspension arm by turning the adjusting tube. Lever length 493.3±1.5 mm.
- G) Temporarily tighten the two locknuts.
Note: After adjusting the rear wheel toe, tighten the locknuts.