Doors, locks and windows of the car Toyota Land Cruiser 60/80

Hinges and locks — care
Every 5,000 km, or every three months, apply a few drops of light oil or lock lubricant to the hinges and latches on the doors, bonnet and boot. Door lock latches also need to be coated with a thin layer of grease to...

Windscreen and fixed glass
Replacing a windshield or fixed glass requires the use of a special fast-curing adhesive or sealant and some specialized tools. It is recommended that these operations be carried out at service stations.

Inner door panel — removal and installation
1. Disconnect the battery from ground. 2. Remove the decorative trim from the interior door handle. 3. On vehicles with manual windows, remove the window handle by removing the latch by prying it off with a thin, curved...

Door lock, lock switch and handles
Door lock 1. Raise the window, remove the inner door panel and the water shield. 2. Working through the openings in the door frame, disconnect the lock rods from the outer and inner handles (on vehicles with electric...

Door glass — removal and installation
1. Remove the inner door panel and water shield. 2. Lower the window completely. 3. Carefully pry up and remove the window seal. 4. Lift the window to provide access to the mounting bolts. The mounting bolt is indicated...

Window lifter — removal and installation
1. Remove the inner door panel and water shield. 2. Remove the door glass. 3. On vehicles with power windows, disconnect the connector from the window motor. 4. Remove the alignment bracket bolts (indicated by arrows)....

Door — removal, installation and adjustment
Attention! Work is performed by two people. Removal and installation 1. Raise the glass. Disconnect the battery from the ground. 2. Open the door and place wooden supports under the door, covering them with rags. 3....

Rear compartment door — removal, installation and adjustment
Attention! Work is performed by two people. Removal and installation 1. Lift the rear compartment door and remove the inner door trim panel. 2. Disconnect all door connectors. 3. Cover the bottom of the opening with a...

Rear cover (upper door of the rear compartment)
Attention! Work is performed by two people. Removal and installation 1. Lift the lid and install the support. 2. Remove the interior panel and disconnect all door connectors. 3. Disconnect the posts on both sides while...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Doors, windows and locks Toyota Corona T190 (1992-1997)
➥ Doors, locks and windows Toyota Highlander 1 (2000-2007, petrol)
➥ Doors, locks and windows Toyota Camry XV10 (1991-1996)
➥ Doors, locks and windows Toyota RAV 4 XA10 (1994-2000)
➥ Doors, locks and windows Toyota 4Runner N120 (1989-1995)

Link in different formats to this article

TEXTHTMLBB Code