Swivel fist — removal and installation Steering knuckle parts 1. Gasket; 2. Sleeve; 3. Pin; 4. Nut; 5. Lever; 6. Bearing; 7. Stuffing box cover; 8. Thrust ring of the gland housing; 9. Fist; 10. Bolt; 11. Bearing cover; 12. Spacer Removing 1. Raise the front...
Steering wheel — removal and installation Removing Attention! Some cars are equipped with an airbag, which is located in a container in the center of the steering wheel. To prevent accidental operation of the system, disconnect the battery from the ground and...
Tie rods — removal, inspection and installation FJ60, 62 steering gear parts 1. Vibration damper; 2. Cotter pin; 3. Bipod; 4, 19. Leading rod tip; 5. Case; 6. Plug; 7. Spring; 8. Ball pin of the rod end; 9. Cotter pin; 10. Leading rod end; 11. Saddle; 12. Ball pin...
Reducer — removal and installation Removing Attention! If the car is equipped with an airbag, then turning the wheels after removing the gearbox is not allowed. Lock the steering wheel by turning the ignition key to the LOCK position, or wrap the seat...
Power steering pump — removal and installation Power steering on 2F and 3F-E engines 1. Pump; 2. Hose; 3. Bolt; 4. Bracket; 5. Belt; 6. Nut; 7. Pulley; 8. Tube Removing 1. Remove the drive belt (see subsection 2.31 ). 2. Remove as much fluid as possible from the...
Removing air from the power steering 1. It is necessary to remove air from the hydraulic drive of the steering wheel during any disassembly of the line. 2. Set the wheels to the straight ahead position. Check the fluid level, restore if necessary, topping...