Automatic transmission Toyota Land Cruiser 100

Gearbox Specifications
General parameters Characteristic Meaning Type 4- or 5-step, A343F, A440F ATF type and volume See Chapter Vehicle settings and routine maintenance Distance from the end of the torque converter to the cut of the...

Automatic transmission (AT) — design description
General information The models considered in this Manual can be equipped with one of two types of 4-speed automatic transmissions (with overdrive): A343F and A440F, and since 2002 - 5-speed AT. All transmissions are...

Diagnostics of AT failures — general information
AT failures most often occur for one of the following five reasons: Reduced engine output efficiency; Violation of regulations; Hydraulic failure; Mechanical damage; Failures of the on-board processor/its signal chain....

Adjusting the gear shift rod
1. Check the freedom of movement of the actuator lever when moving the shift rod from the "P" position to all other transmission positions - if the selector indicator reading does not match the actually selected...

Checking, adjusting and replacing the start enable switch sensor
Examination The switch-sensor enables the engine to start only in two AT positions: "P" and "N". If the engine starts in any other lever position, the start-permission switch-sensor is faulty or its adjustment is...

Removal and installation the AT selector lever assembly
1. Remove the upper panel of the rear console (see chapter Body ). 2. Remove the switch handles and dismantle the seat heating control panel. 3. Remove the transfer case shift lever handle. 4. Jack up the car and place...

Removal and installation of automatic transmission
Removal Typical AT installation diagram 1 - ATF level measuring dipstick; 2 - Heater control panel; 3 - Heater control handles; 4 - Transfer case mode shift lever handle; 5 - Central section of instrument panel trim; 6...

Transfer case — general information
The vehicles in question have permanent all-wheel drive and are equipped with a HF2A or HF2AV transfer case mounted directly behind the AT. The engine torque is transmitted through the transmission and transfer case to...

Removal and installation the transfer case
Transfer case installation details 1. Jack up the car and place it on supports. 2. Loosen the 3 bolts securing the transfer case protective cover and remove it. 3. Drain the oil from the transfer case. 4. Remove the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Automatic gearbox Toyota RAV 4 XA10 (1994-2000)
➥ Automatic gearbox Toyota Camry Vista V40 (1994-1998)
➥ Automatic gearbox Toyota Duet (1998-2004)
➥ Automatic gearbox Toyota Corona T190 (1992-1997)
➥ Automatic gearbox Toyota Carina T190 (1992-1996)
➥ Automatic gearbox Toyota Corolla E80 (1983-1990)

Link in different formats to this article

TEXTHTMLBB Code