Car transfer case Toyota Land Cruiser 70

Replacing the front and rear output shaft seals
1. Drain the oil from the transfer case. 2. Remove the front and rear propeller shafts. 3. Removing the output shaft connecting flange. a) Using a hammer and chisel, loosen the countersunk portion of the lock nut. b)...

Disassembling the transfer case
1 - O-ring, 2 - adapter gasket, 3 - front crankcase cover assembly, 4 - low gear engagement sensor (L4), 5 - front bearing retainer, 6 - high-low gear shift fork assembly, 7 - rear output shaft assembly, 8 - spacer, 9 -...

Rear Output Shaft Assembly
Rear output shaft assembly. 1 - retaining ring, 2 - all-wheel drive engagement hub, 3 - front output shaft bearing, 4 - high gear pinion, 5 - needle bearing, 6 - needle bearing, 7 - rear output shaft, 8 - fork rod, 9 -...

Intermediate gear assembly
Intermediate gear assembly. 1 - thrust washer, 2 - needle bearing, 3 - spacer, 4 - oil deflector ring, 5 - intermediate gear assembly, 6 - thrust washer, 7 • ring gasket, 8 - intermediate gear shaft. Disassembly,...

Rear Output Shaft Bearing Holders
Rear output shaft bearing holders. 1 - front bearing holder, 2 - outer bearing race, 3 - outer bearing race, 4 - adjusting washer, 5 - oil deflector plate, 6 - rear bearing holder, 7 - oil seal, 8 - speedometer driven...

Front crankcase cover
Front crankcase cover. 1 - diaphragm mechanism, 2 - gasket, 3 - actuator housing, 4 - gasket, 5 - front crankcase cover, 6 - fork rod, 7 - retaining ring, 8 - all-wheel drive engagement fork, 9 - spring, 10 - thrust...

Pneumatic drive — disassembly, assembly
Pneumatic drive. 1 - diaphragm mechanism housing, 2 - seal, 3 • fitting, 4 - cover, 5 - plate, 6 - diaphragm, 7 - end gasket, 8 - diaphragm rod, 9 - gasket, 10 - actuator housing, 11 - support, 12 - lever axis, 13 -...

Transfer case housing
Transfer case housing. 1 - inner high-low gear shift lever, 2 - oil seal, 3 - washer, 4 - outer high-low gear shift lever, 5 - spring washer, 6 - nut, 7 - housing. Disassembly, inspection and assembly 1. Loosen the...

Transfer case assembly
1. Installing the front crankcase cover. a) Clean the bolts and bolt holes from any remaining sealant. b) Apply sealant to the threads of the front cover mounting bolts. Sealant: Part # 088330-00070, Three Bond 1324 or...

Cardan shaft
Front and rear propeller shafts. 1 - joint flange, 2 - grease nipple, 3 - universal joint crosspiece, 4 - universal joint crosspiece bearing, 5 - retaining ring, 6 - joint flange, 7 - universal joint shaft, 8 - dust...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Transfer case Toyota 4Runner N120 (1989-1995)

Link in different formats to this article

TEXTHTMLBB Code