Removal and installation
Note: Installation is in the reverse order of removal.
1. Disconnect a wire from the negative plug of the storage battery.
2. Turn away two screws, disconnect clamps, a socket and remove the bottom furnish of the panel of devices from outside the driver.
3. (Models with automatic transmission selector on the steering column)
Remove the trim of the automatic transmission selector hole:
A) Switch the selector lever to position "N".
b) Stick the protective tape on the center console.
V) Disconnect the piston, retainer and remove the trim.
4. Remove the rear trim of the center console.
A) Remove the center console rear trim cover.
b) Turn away bolts, disconnect clamps and remove back furnish of the console.
5. Turn away screws and remove forward furnish of the central console.
Removal and installation of the instrument panel (Duet).
1 - lower trim of the instrument panel on the driver's side,
2 - instrument cluster trim,
3 - instrument cluster,
4 - finishing of the central part of the instrument panel,
5 - glove box,
6 - instrument panel,
7 - passenger airbag.
Removal and installation of the instrument panel (Sirion).
1 - lower trim of the instrument panel on the driver's side,
2 - instrument cluster trim,
3 - instrument cluster,
4 - finishing of the central part of the instrument panel,
5 - glove box,
6 - instrument panel,
7 - passenger airbag.
6. Turn away 4 bolts and remove the top and lower casings of a steering column and a steering wheel in gathering.
Note: Turn steering wheel when removing.
7. Turn away 3 bolts and a nut and remove a steering column in gathering.
8. Turn off 2 screws, disconnect caps and clamps and remove finishing of a combination of devices.
9. Disconnect caps and clamps and remove finishing of the central part of the panel of devices.
10. Turn away 4 screws and remove a combination of devices.
11. Turn away 4 bolts and remove a radio tape recorder.
12. Turn away 3 bolts and remove the panel of management of a heater/conditioner.
13. Turn away 2 bolts and remove furnish of an ashtray.
14. Remove a ware box.
A) Disconnect the limiters from the glove box.
b) Disconnect stoppers, clamps and remove a ware box.
15. Turn away 3 bolts and remove an additional ware box.
16. Remove the passenger airbag.
A) Disconnect the passenger airbag connector.
b) Remove the 2 nuts and bolt and remove the passenger airbag module.
V) Loosen the latch and remove the passenger airbag.
17. Using a screwdriver wrapped with protective tape, remove the tweeter cover as shown.
18. Turn away 2 screws, disconnect a socket and remove high-frequency speaker.
19. (Models with side airbags)
Remove the airbag cover.
20. (Models with side airbags)
Turn away a bolt and remove furnish of a forward rack.
21. Turn away 7 bolts and disconnect the panel of devices.
22. Turn away 5 bolts and remove a deflector of heating of a windshield.
23. Turn away a bolt and remove an air duct.