Note: Installation is carried out in the reverse order of removal.
When installing, please pay attention to the following operations:
1. Install the drive shaft.
a) Apply special grease to the surface of the inner joint.
b) Install the inner joint shaft and put on the retaining ring.
c) Lock the nut.
Note: To avoid premature wear, install the lock nut as shown in the figure.
2. Install the anti-roll bar.
3. Fill the gearbox with oil.
4. Install the front wheel.
- Wheel tightening torque - 87-118 Nm
[The full article is posted on the website: www.ToyotaMAN.ru]
5. Remove the car from the jack.