a) Check the height of the sunroof relative to the roof of the car, as shown in the figure.
b) Check the width of the hatch seal as shown in the figure.
2. Adjust the height of the hatch.
a) Remove the inner side trim of the hatch using a screwdriver.
b) Adjust the height of the hatch by changing the thickness of the adjusting plates.
[The original is this website: ToyotaMan.ru]
Note: After completing the adjustment, install the inner side trim of the sunroof.
3. Adjust the gap between the front corners of the sunroof and the vehicle roof panel.
a) Set the hatch to the closed position.
b) Disconnect the electric motor drive from the cables.
c) Remove the sunroof glass.
d) Adjust the gap by moving the hatch mounting bracket forward and backward relative to the marks shown in the figure.
d) Install previously removed parts in the reverse order of removal.
4. Adjustment of the hatch in longitudinal and transverse directions.
To adjust, loosen the hatch mounting bolts shown in the figure and adjust the position of the hatch.
