1. Remove the following parts:
a) Remove the rear seat cushion and backrest.
b) Remove the upper rear pillar trim.
c) Remove the additional brake light.
d) Remove the rear shelf.
d) Remove the front trunk trim.
e) Disconnect the rear window defroster wire connectors.
2. Remove the lower molding by disengaging the seven clips as shown.
3. Remove the rear window molding.
4. When removing the molding, be careful not to damage the fasteners. The locations of the fasteners are shown in the figure.
5. Remove the rear glass.
a) Pull the string out of the passenger compartment and secure the ends of the string to wooden blocks.
Use a string to cut away the layer of glue and remove the glass.
Caution: When cutting, leave as much glue on the body as possible.
Note: Please stick adhesive tape on the outer surface of the rear glass to avoid scratching the surface.
Caution: When removing the glass, be careful not to damage painted surfaces and interior trim.
b) Using a special tool, cut off the adhesive layer and remove the glass.
Caution: When cutting, leave as much glue on the body as possible.