- Standard thickness - 10.0 mm
- Minimum thickness - 1.0 mm
Replace the brake pads if the brake lining thickness is less than the minimum permitted or if uneven lining wear is detected.
2. Using a caliper, measure the thickness of the brake disc.
- Standard thickness - 10.0 mm
- Minimum thickness - 9.0 mm
Replace the disc if the disc thickness is less than the minimum allowable.
3. Measure the runout of the brake disc at a distance of 10 mm from the outer edge.
- Maximum runout - 0.15 mm
Note: Before measuring brake disc runout, make sure the rear wheel bearing axial clearance meets specifications.
4. If necessary, replace the brake disc.
a) Remove the caliper bracket.
b) Loosen the wheel nuts and remove the disc.
c) Install the new brake disc and temporarily secure it with wheel nuts.
d) Install the caliper bracket and tighten the mounting bolts.
The text is taken from the specified website [www.TOYOTAMAN.ru]
- Tightening torque - 47 Nm
