Resetting ABS system fault codes [Toyota Carina T190]

1. Turn on the ignition.

2. Short the T terminals_with and E ₁ diagnostic connector.

Note: This operation must be performed with the vehicle stationary.

3. Press the brake pedal eight or more times within 3 seconds to clear the fault codes stored in the ABS control unit memory.

4. Make sure that the indicator flashes correspond to the normal state code (interval 0.5 seconds).

5. Turn off the ignition.

6. Disconnect the T terminals_with and E ₁ diagnostic connector.

7. Make sure the ABS indicator goes out.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kondratyeva Ulyana

Share information:

◀ Previous

Carina T190: Brake system

Next ▶

Checking the ABS system
Anti-lock braking system (ABS) device
Description of the ABS diagnostic system
Pressure regulator (P-valve) — checking liquid pressure
Installing the parking brake

Diagnostics of ABS system speed and deceleration sensors
Pressure modulator device
Slowdown sensor device
ABS control unit device
ABS Pressure Modulator — Removal