Normal startup process (with a cold engine)
1. Manual transmission: set to idle and keep the clutch pedal depressed until the engine starts. Automatic transmission: move selector lever to position «R» or «N» (recommended «R»).
2. Fully depress the pedal once «gas» and let her go. This sets the starting automatic and increased idling.
3. Turning the ignition key to position «START», start the starter without pressing the pedal «gas». Release the ignition key when the engine starts. Do not keep the starter running continuously for more than 15 seconds.
4. After the engine has been running for about 10 seconds, you can start driving. Remember that a cold engine must not be operated at high speeds.
If the air temperature is below zero or the car has been parked for several days
Press the pedal before starting «gas» two or three times. This creates an enriched cold start mixture.
Start the starter without depressing the pedal «gas».
After the engine has been running for about 30 seconds, briefly depress the pedal «gas», to decrease the idle speed.
Warm up the engine for a couple of minutes before driving. Do not leave the vehicle while the engine is warming up.
With a warm engine
When starting the engine, keep the pedal «gas» about half pressed. Not «download» pedal.
With the engine hot enough, fully depress the pedal «gas» at startup.
If the engine is warm or hot and does not want to start, there may be too much fuel in it
Squeeze out the pedal «gas» and leave in this position for 15-20 seconds. B Start the engine with the pedal depressed «gas». It may be necessary to keep the starter engaged continuously for 20-30 seconds until excess fuel is removed and the engine starts. If the engine does not start, wait a few minutes and repeat the process. Not «download» pedal, keep it pressed down.