Attention: The check is carried out in the following sequence.
Remove distributor cap.
Turn on the ignition.
Checking the primary winding of the coil
Use an ohmmeter to measure the resistance between the positive (+) and negative (-) contacts and compare it with the set value given in the table.
Checking the secondary winding of the coil
Use an ohmmeter to measure the resistance between the positive (+) and negative (-) contacts of the high-voltage part of the coil and compare with the set value given in the table.
If the measured resistances do not match those given in the table, the ignition coil must be replaced.
Removing the ignition coil (IZA, ESA systems)
Remove the two mounting bolts and remove the ignition distributor cover.
Disconnect terminals (+) And (-) from the coil of wire.
Loosen the mounting bolts to the holder and remove the ignition coil.
Installation
Install and secure the ignition coil
Connect terminals (+) And (-) coils for wires.
Replace the distributor cover and secure it with screws.