Note: Install in the reverse order of removal.
When installing, please pay attention to the following operations:
1. Using a special tool, install the torque converter plate.
2. Install the torque converter.
a) Before installing the torque converter, measure the distance "A" as shown in the figure.
- Nominal distance - 29 mm
3. Install the gearbox.
a) Install and adjust the throttle valve control cable.
b) Clean the gearbox housing oil seal holes from dirt.
c) Install the gearbox. Check the correct installation of the gearbox, the alignment of the shaft holes, and the alignment of the marks.
Note: If the gearbox is installed incorrectly, remove it and install it again.
The material was taken from a resource Toyotaman.ru
4. Tighten the gearbox mounting bolts.
Note: Make sure the torque converter bolts do not contact the pump cover.
