Front seats
Power seats and the location of its components
1. On models equipped with power seats, disconnect the negative cable from the battery.
Attention! If the stereo system installed in the car is equipped with a security code, before disconnecting the battery, make sure that you have the correct combination to activate the audio system!
2. Remove carpets and disconnect electrical wiring.
3. Remove the seat slide covers.
4. Turn out fixing bolts and remove assemblage of a seat (refer to accompanying illustration).
5. Disconnect the connector from the power seat motor (refer to the illustration at the beginning of the Section).
6. Give bolts of fastening of the motor to a frame and remove it.
7. Installation is carried out in the reverse order. Track reliability of a tightening of fixture.
Rear seats
1. Release the locks on both sides of the seatback.
2. Remove the pads and turn out the bolts of the front fastening of the seat to the floor. To remove the backrest, unscrew the bolts of the central hinge and the axle bolts on both sides. Remove the cushion and back.
3. Apply sealant to the threaded holes and install the seat cushion and backrest. Tighten the floor bolts to the required torque.