Power steering on 2F and 3F-E engines
1. Pump; 2. Hose; 3. Bolt; 4. Bracket; 5. Belt; 6. Nut; 7. Pulley; 8. Tube
Removing
1. Remove the drive belt (see subsection 2.31).
2. Remove as much fluid as possible from the reservoir, disconnect and plug the high pressure hose and tube.
3. On vehicles with 2F and 3F-E engines, remove the front pump mounting bolts. On vehicles with a 1FZ-FE engine, remove the bolts securing the pump to the cylinder block.
Installation
1. Installation is carried out in the reverse order.
2. Tighten bolts and nuts to specified torque. On vehicles with a 1FZ-FE engine, replace the pump O-ring.
3. Bleed the air from the hydraulic (see subsection 9.13).