Contents: Removal ↓ Installation ↓
Removal
1. Jack up the car.
2. Remove the wheel.
3. Drain the oil from the rear gearbox.
4. (Models with ABS)
Remove the rear wheel speed sensor.
5. Disconnect the brake pipe and brake hose.
6. Remove the brake drum.
7. Remove the brake mechanism.
8. Disconnect the rear axle shaft.
9. Using a special tool and a press, remove the bearing.
10. Using a special tool, remove the oil seal.
Installation
1. Install the oil seal using a special tool.
2. Press in the bearing.
3. Install the rear axle shaft.
Note: Do not damage the oil seal.
4. Connect the brake pipe and brake hose
5. Install the brake drum.
6. Connect the brake pipe and brake hose and tighten the union nut.
- Tightening torque: 13-18 Nm
7. (Models with ABS) Install the wheel speed sensor.
8. Fill the rear gearbox with oil.
9. Install the wheel.
- Tightening torque - 88 - 118 Nm
10. Lower the vehicle.
11. Fill with brake fluid and bleed the brake system.
Rear axle shaft.
1 - oil seal,
2 - half shaft,
3 - bearing,
4 - spacer.