Removing
1. Drain the coolant.
2. Disconnect a wire from the negative plug of the storage battery.
3. Remove the air filter.
4. Remove the throttle body (see chapter "fuel injection system (EFI)").
5. Disconnect all connectors, hoses, grounds, etc.
6. Turn away bolts and nuts, remove an inlet collector.
Installation
1. Install a new gasket on the intake manifold.
2. Install the intake manifold and tighten the bolts and nuts in the sequence shown in the figure.
3. Install the throttle body.
4. Install the air filter.
5. Connect a wire to the negative plug of the storage battery.
6. Fill in coolant.
Removal and installation of the intake manifold.
1 - vacuum hose of the absolute pressure sensor at the inlet,
2 - vacuum brake booster hose,
3 - ventilation system hose,
4 - intake manifold,
5 - gasket.