Removal and installation
1. Disconnect a wire from the negative plug of the storage battery.
2. Remove the intake air pressure sensor, the intake air temperature sensor, disconnect the connector of the electro-pneumatic valve of the fuel vapor recovery system.
3. Remove the air filter housing.
4. Install the air filter housing.
5. Install the intake pressure sensor into the air cleaner housing until it clicks into place.
6. Connect the hoses as shown.
1 - vacuum hose,
2 - hose No. 2 of the fuel vapor accumulator,
3 - hose No. 1 of the fuel vapor accumulator.
5. Connect a wire to the negative plug of the storage battery.