Removing
1. Drain the coolant.
2. Disconnect a forward reception pipe of system of release.
3. Remove the ground screw.
4. Remove the power steering pump drive belt.
5. Remove the power steering.
Note:
- Do not disconnect tubing from the pump.
- Hang the pump on a rope.
6. Turn away bolts and nuts, remove a final collector.
Installation
1. Install a new exhaust manifold gasket with the tab side facing the cylinder head.
2. Establish a final collector and wrap bolts and nuts of its fastening, as it is shown in drawing.
Removing and installing exhaust manifold.
1 - exhaust manifold heat shield,
2 - exhaust manifold rack,
3 - oxygen sensor,
4 - heat shield wiring,
5 - exhaust manifold,
6 - gasket.
3. Install the power steering.
4. Install the power steering pump drive belt.
5. Install the ground bolt.
6. Connect a forward reception pipe of system of release.
7. Fill in coolant.