Camry Corolla Corona Carina Land Cruiser Highlander 4Runner RAV4 Others

Duet (1998-2004) Dyna Y50/Y60 (1984-1995)

Replacing the rear crankshaft oil seal [Toyota Duet M100]

0

Replace the rear crankshaft oil seal.

a) Remove the holder from the cylinder block.

b) Use a screwdriver to remove the rear crankshaft oil seal from the holder.

c) Using a drift, install a new seal.

The text is taken from the specified website: ToyotaMan.ru

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kolokoltsev Grigory

Share information:

◀ Previous

Duet: Engine overhaul

Next ▶

Checking the crankshaft
Checking the condition of the piston and connecting rod
Disassembling the piston-connecting rod assembly
Cylinder block boring
Cylinder Block — Disassembly

Assembling the piston-connecting rod unit
Cylinder block — assembly (KZ series)
Cylinder Block — Assembly (EJ Series)

Similar articles on other Toyota models

➥ Replacing the rear crankshaft seal ring Toyota Camry XV10 (1991-1996)
➥ Replacing the rear crankshaft oil seal Toyota Corolla Verso 3 (2004-2009)
➥ Replacing the rear crankshaft oil seal Toyota Cruiser 100 (1998-2007)
➥ Replacing the output shaft seal (rear wheel drive) (A540N) Toyota Corona T190 (1992-1997)
➥ Rear Crankshaft Oil Seal — Replacement Toyota 4Runner N120 (1989-1995)
➥ Rear crankshaft oil seal Toyota RAV 4 XA10 (1994-2000)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

We require cookies to enable some interactive features. Is that ok with you?