Removing and installing the speed controller.
1 - retaining ring,
2 - cover,
3 - sealing ring,
4 - speed controller,
5 - ball.
Note: Install in the reverse order of removal.
1. Remove the retaining ring.
2. Remove the cover with the sealing ring and take out the speed controller.
3. Use a magnet to remove the ball.
Checking the speed controller
1. Check the ball and speed controller for damage (pay special attention to the places indicated in the picture).
Note: If any parts are damaged, replace them.
Removing the selector lock cables and ignition switch.
1 - pedal,
2 - center console,
3 - selector trim,
4 - bolt,
5 - nut,
6 - steering wheel pads,
7 - pedal pad,
8 - selector lock cable.
Removal and installation of electromagnetic valves.
1 - electromagnetic switching valve (SOLR),
2 - electromagnetic valve of torque converter lock-up (LUCC),
3 - electromagnetic valve of partial lock-up of the torque converter (LUCR),
4 - electromagnetic valve No.3,
5 - electromagnetic valve No.2,
6 - electromagnetic valve No.1,
7 - electromagnetic valve wiring harness,
8 - O-ring seal.
[The original is this website: ToyotaMan.ru]