Camry Corolla Corona Carina Land Cruiser Highlander 4Runner RAV4 Others

Duet (1998-2004) Dyna Y50/Y60 (1984-1995)

Removal and installation the speedometer drive cable seal [Toyota Duet M100]

0

1. Disconnect the speedometer drive cable.

2. Remove the speedometer drive cable shaft.

3. Remove the oil seal using a special tool.

4. Check the shaft and pinion for damage.

Note: If damage is found, replace the part.

5. Press in the new oil seal as shown in the figure.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kolokoltsev Grigory

Share information:

◀ Previous

Duet: Automatic gearbox

Next ▶

Replacing the gearbox input shaft seals
Replacing oil seals
Gearbox installation
Gearbox — check
Removal the gearbox

Removal and installation coolant hoses
Replacing the working fluid filter
Removal and installation the speed controller
Selector lock cable
Engine start inhibit switch

Similar articles on other Toyota models

➥ Hood lock and lock drive cable Toyota Camry XV20 (1996-2001)
➥ Replacing the timing chain or belt drive cover seal Toyota Corolla Verso 3 (2004-2009)
➥ Replacing the output shaft seal (rear wheel drive) (A540N) Toyota Corona T190 (1992-1997)
➥ Drive shaft seal assembly (A241L, A241E, A245E) Toyota Carina T190 (1992-1996)
➥ Hood Latch and Drive Cable — Removal and Installation Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Rear gearbox oil seal (on rear-wheel drive vehicles) Toyota 4Runner N120 (1989-1995)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

We require cookies to enable some interactive features. Is that ok with you?