Checking the normal idle speed [Toyota Dyna Y50]

1. Connect the tachometer.

2. Warm up the engine to normal operating temperature.

3. Check the idle speed:

For engines

with manual transmission - 700 rpm
with automatic transmission - 750 rpm

(The material was taken from a resource: www.ToyotaMan.ru)

If the idle speed does not match the specified values, one of the following methods must be used for adjustment.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Evdokimov Evgeniy

Share information:

◀ Previous

Dyna Y50/Y60: Checks and adjustments

Next ▶

Adjusting the ignition timing angle
Checking the lubrication system
Checking drive belts
Checking the cooling system
Cleaning the air filter (oil type)

Preliminary checks of the carburetor
Adjusting the frequency and composition of the idle mixture using a gas…
Alternative method of adjusting normal idle speed and mixture composition
Adjusting the increased idle speed
Adjusting the rotation speed set by the throttle valve opening mechanism

Similar articles on other Toyota models

➥ Checking the generator electrical circuit at idle speed Toyota Camry XV30 (2001-2006)
➥ Checking and adjusting idle speed and CO concentration Toyota Corolla E80 (1983-1990)
➥ Checking the idle speed (N range) Toyota Corona T190 (1992-1997)
➥ Checking and adjusting the idle speed when turning on the… Toyota Carina T190 (1992-1996)
➥ Idle Speed Control Valve — Checking and Replacing Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Speed sensor — checking and replacement Toyota 4Runner N120 (1989-1995)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet