Checking the generator bearings [Toyota Carina T190]

1. Check the front bearing. Check that the front bearing moves smoothly and without sticking.



2. Replace the bearing if necessary.

a) Unscrew 4 screws and remove the bearing holder.



b) Using a press and a socket of the appropriate size, press out the front bearing.



c) Using a special punch and press, press the new front bearing into the generator cover on the drive side.





(The publication is taken from the website: www.TOYOTAMAN.ru)

d) Install the bearing holder and tighten the 4 screws that secure it.

• Tightening torque - 2.6 Nm

3. Check the rear bearing. Check that the rear bearing moves smoothly and without sticking.



4. Replace the rear bearing if necessary.

a) Using a puller, remove the rear bearing and bearing cap.



b) Using a press, install the new rear bearing onto the rotor shaft.



c) Install the bearing cover.