Removing
Disconnect ground cable (-) from the battery.
Attention: This will erase the entries in the memory of the on-board computer. In particular, fault records and radio code. Before disconnecting the battery, read the contents of the section «Removing and installing the battery».
Remove the radio.
Remove steering wheel.
Remove dashboard kit.
Remove left loudspeaker trim.
Loosen the screws and remove the hood lock lever.
Remove 6 screws and remove lower trim. Remove the lower trim on the passenger side next to the driver in the same way.
Unscrew the heating air duct fastening screw under the removed lining and remove the air duct.
Unscrew the screws securing the left outer trim at the front panel and remove it.
Loosen the screws securing the loudspeaker holder and disconnect the cable from it.
Remove two screws and cover «glove compartment» with loops.
Loosen the fixing screws and remove the cover latch «glove compartment».
Unscrew the screws securing the visor at the center console to eliminate reflections from the windshield and remove it. Then remove the center console from the front panel.
Loosen the fixing screws and remove the heating control panel. Do not disconnect tie rods.
Remove the grille from the upper air nozzles with a screwdriver.
Unscrew the 3 hex head screws and 3 slotted screws and remove the front panel.
Installation
Install the front panel elements in the reverse order of removal.
Connect ground cable (-) with rechargeable battery.
Set the time on the clock, if any, and enter the alarm code into the radio receiver.