Transfer case housing. 1 - internal shift lever in upper-lower gears, 2 - oil seal, 3 - washer, 4 - outer shift lever of higher-lower gears, 5 - spring washer, 6 - nut, 7 - crankcase.
Disassembly, inspection and assembly
1. Remove the bolt, nut, spring washer and two washers.
2. Remove the outer shift lever and washer, then remove the inner shift lever.
3. Replacing the oil seal of the inner shift lever (if necessary).
A) Using a flat blade screwdriver, pry out the oil seal.
b) Using a mandrel and a hammer, press in a new oil seal.
V) Apply grease to the seal lip.
4. Install the inner shift lever, then install the washer and outer shift lever.
5. Install the nut, spring washer, two washers and tighten the bolt.
Attention: when assembling, do not damage the sealing lip.