Removal and installation
Note:
- Removal is carried out in accordance with the figure "Removing the pressure regulator".
- Install in the reverse order of removal.
Pressure regulator.
Examination
1. Install pressure gauges and bleed the brake system (see picture "Checking the pressure in the brake system").
2. Pressurize the front brake circuit according to the pressure regulator schedule and check the pressure in the rear circuit.
Pressure regulator schedule.
Checking the pressure in the brake system
Dismantling the front brakes (except models with disc 14" since 2001).
1 - guide pin,
2 - anther,
3 - brake shoe,
4 - retaining plate insert,
5 - anti-creak gasket,
6 - caliper bracket,
7 - support,
8 - piston,
9 - cuff,
10 - anther,
11 - retaining ring.
Note: Apply special grease that does not damage rubber to the indicated surfaces.
Dismantling the front brakes (models with 14 disc" since 2001).
1 - caliper mounting bolt,
2 - guide pin,
3 - caliper bracket,
4 - brake shoe,
5 - retaining plate insert,
6 - brake shoe,
7 - anti-creak gasket,
8 - anther guide pin,
9 - piston boot,
10 - piston,
11 - seal.
Note: Apply special grease that does not damage rubber to the indicated surfaces.
Front brakes.
1 - guide pin,
2 - brake shoe,
3 - anti-creak gasket,
4 - retaining plate insert,
5 - nipple bolt,
6 - gasket,
7 - support,
8 - brake disc.