Remove the oil filler plug, unscrew the drain plug on the oil pan and drain the oil into a suitable container.
2. Replace the oil filter.
a) Unscrew the oil filter using a suitable tool.
b) Check and clean the surface of the block on which the filter is installed.
c) Apply a small amount of fresh engine oil to the gasket of the new filter.
d) Use your hand to tighten the filter until you feel significant resistance.
d) Then, using the puller, tighten the filter by 3/4 of a turn.
3. Fill the engine with fresh oil.
a) Clean and install the drain plug with a new gasket. Tighten the plug to the specified torque.
- Tightening torque - 25 Nm
b) Fill with fresh engine oil of the required quality.
[The article is taken from a web resource www.toyotaman.ru]
Lubrication system capacity:
- without changing the oil filter - 3.0 l
- with oil filter change - 3.5 l
- filling oil into a dry engine - 4.2 l
c) Install the oil filler cap with a new gasket.
4. Start the engine and check for leaks.
5. Check the oil level and top up if necessary.