Checking the key presence sensor in the ignition switch [Toyota Carina T190]

Check the conductivity between terminals "1" and "2" of the connector with the key inserted into the ignition switch and the absence of conductivity with the key removed.

[The original text is posted on: toyotaman.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kondratyeva Ulyana

Share information:

◀ Previous

Carina T190: Equipment and devices

Next ▶

Checking the central lock switch (in the door lock)
Checking the central lock switch
Checking the door lock control relay of the central locking system
Checking the door lock control relay of the window lift system
Checking the window lift motors

Checking the door limit switch
Checking the door lock electric drive
Remote lock — check
Remote lock receiver and transmitter
Electric sunroof drive — device

Similar articles on other Toyota models

➥ Ignition Interlock Switch — Checking and Replacing Toyota Camry XV20 (1996-2001)
➥ Checking the fan switch temperature sensor Toyota Corolla E80 (1983-1990)
➥ Checking the center differential lock indicator switch… Toyota Corona T190 (1992-1997)
➥ Checking, adjusting and replacing the start enable switch… Toyota Cruiser 100 (1998-2007)
➥ Ignition switch and lock drum — checking and replacement Toyota 4Runner N120 (1989-1995)
➥ Brake light switch (contact sensor) — checking, removing… Toyota RAV 4 XA20 (2000-2005)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet