If there is no continuity between the specified terminals, replace the selector release switch.
If there is no continuity between the specified terminals, replace the selector release switch.
Checking the selector release switch [Toyota Carina T190]
1. Disconnect the switch connector and check the continuity between the connector terminals indicated in the table.
If there is no continuity between the specified terminals, replace the selector release switch.
If there is no continuity between the specified terminals, replace the selector release switch.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
The article material has been checked: Kondratyeva Ulyana
Share information:
Similar articles on other Toyota models
➥ Reverse Light Switch — Checking and Replacing Toyota Camry XV20 (1996-2001)
➥ Checking the fan switch temperature sensor Toyota Corolla E80 (1983-1990)
➥ Checking the clutch release slave cylinder Toyota Corona T190 (1992-1997)
➥ Automatic transmission selector rod — checking and… Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Front Axle Drive Switch — Checking and Replacing Toyota 4Runner N120 (1989-1995)
➥ Checking and replacing the reverse light switch Toyota RAV 4 XA10 (1994-2000)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engines 4A-FE, 5A-FE, 7A-FE
- Engines 3S-FE, 4S-FE
- Diesel engines 2C
- Engine repair
- Cooling system
- Lubrication system
- Fuel system
- Control system (diesel)
- Fuel injection system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts
- Chassis, running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Air conditioning and heater
- Electrical equipment
- Equipment and devices
- Headlights and lighting
- Breakers and switches
- Electrical circuits
- General information
- Introduction to the manual
- Power unit
- Gasoline engines
- Diesel engines
- Lubrication system
- Cooling system
- Fuel system (carburetor)
- Fuel system (injector)
- Ignition system
- Transmission
- Clutch
- Car gearbox
- Drive shafts
- Chassis, running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Electrical equipment
- Power devices
- Electrical circuits