Note: For the procedure for changing the oil in the transfer case, see chapter "Maintenance".
1 - transfer case oil pipe,
2 - adjusting gasket,
3 - O-ring seal,
4 - oil seal,
5 - anther,
6 - driven gear bearing holder,
7 - center differential lock system indicator sensor (with mechanical locking),
8 - bushing,
9 - cork,
10 - transfer case inspection hole cover,
11 - interaxle differential lock engagement fork (with mechanical locking),
12 - interaxle differential lock clutch (with mechanical locking),
13 - transfer case cover,
14 - adjusting nut lock plate,
15 - retaining ring,
16 - intermediate shaft support bearing of axle gears,
17 - interaxle differential lock engagement fork rod (with mechanical locking),
18 - boot (with mechanical locking),
19 - transfer case housing,
20 - washer,
21 - outer bearing ring,
22 - shaft of the main transmission drive gear assembly (with mechanical locking),
23 - outer bearing ring,
24 - adjusting nut,
25 - transfer case housing extension,
26 - intermediate shaft holder of axle gears,
27 - oil seal (with mechanical locking),
28 - cork (with viscous coupling),
29 - plug (with viscous coupling).