Removing
Note: Install in the reverse order of removal.
1. Remove the speed sensor and the speed sensor rotor.
- A) Remove the protective plate and speed sensor. Tightening torque when installing 5.4 Nm.
- b) Remove the O-ring from the speed sensor
- V) Loosen the two screws and remove the sensor cover bracket. Tightening torque when installing 5.4 Nm.
- G) Remove the sensor cover using a screwdriver.
Note: Wrap the end of the screwdriver with duct tape to avoid damaging the cover or gearbox housing.
- d) Remove the O-ring from the sensor cover.
- e) Remove the sensor rotor.