Contents: Front heater ↓ Rear heater ↓
Warning! Some vehicles covered in this manual are equipped with a Supplemental Restraint System (SRS), commonly known as an airbag. Before performing any work near the airbag assembly or steering column, always disable the system to avoid injury from accidental deployment - disconnect the negative battery cable first, then the positive cable, and wait at least two minutes before servicing components located near the directional overload sensors (see On-board electrical equipment). The insulation and connectors of the SRS circuit wiring are painted bright yellow. Do not connect any diagnostic equipment to this circuit!
Front heater
Front Heater Control Panel Assembly. Land Cruiser Models
1. Using a thin screwdriver, remove the two fasteners, ashtray and cup holder.
2. Remove the console trim from the front heater control panel (refer to the illustration above).
3. Pull out the control unit and disconnect the electrical wiring.
4. Installation is carried out in reverse order.
5. Start the engine and check the heater/air conditioner for proper operation.
Rear heater
Rear Heater Control Panel Assembly. Land Cruiser Models
1. Remove the rear cover of the unit and turn on the heater to maximum.
2. Loosen the three screws and remove the control unit (refer to the illustration above).
3. Disconnect the electrical wiring connector and control cable.
(The original can be found on this resource: www.ToyotaMan.ru)
4. Installation is carried out in reverse order.
5. Start the engine and check the heater/air conditioner for proper operation.