Common parameters
Characteristic | Meaning |
Type | 4 or 5 speed, A343F, A440F |
Type and volume of ATF | see chapter Vehicle settings and routine maintenance |
Distance from the end of the torque converter to the cut of the transmission bell, mm | at least 17.1 |
Tightening force of threaded connections, Nm
Connection type | Meaning |
ATF temperature sensor | 15 |
Retaining ring to valve body | 10 |
ATF drain plug | 20 |
Bolts of fastening of the pallet to the case АТ | 74 |
Bolt of fastening of the gauge-switch of permission to start | 13 |
The sensor switch of permission of start to the control lever АТ | 13 |
Nut of the sensor-switch of permission to start | 4 |
VSS sensor base to AT body | 16 |
VSS sensor housing to AT housing | 5.4 |
Bolts of fastening АТ to the engine | 72 |
Fixture of tubes of an oil cooler to the case АТ | 32 |
Position latch bracket P to AT body | 7.4 |
solenoid valve body | 11 |
Nut of fastening of draft of switching to the selector lever | 13 |
Bolts of fastening of the case of valvate assembly | 10 |
Transfer case. Type HF2A (V)
Tightening force of threaded connections, Nm
Connection type | Meaning |
Connecting flange nuts (front and rear) | 106 |
Bolts of fastening of a protective casing of a distributing box to a cross beam | 28 |
Bolts of fastening of a distributing box to AT | 69 |
Bolts of fastening of a cross beam | 50 |
Nuts of fastening of a cross beam | 74 |
Fill and drain plugs | 37 |
Fasteners for the front and rear housings and their covers | 37 |
Rear housing to mount | 39 |
Transfer case control lever retainer | 12 |
Actuator electric motor to the front housing | 18 |
Screw plug to front housing | 19 |
Screw plug to rear housing | 29 |
Speed sensor drive gear (VSS) | 11 |
Transfer case mode sensors | 37 |
Control rod assembly to lever | 14 |
Oil intake mesh to the rear housing | 4.9 |
Oil pickup to front housing | 12 |
Oil pump base plate | 43 |
Oil pump cover | 4.9 |